AKG P820 Tube

รหัสสินค้า : AKG P820 Tube

 AKG P820 Tube ไมโครโฟนแบบ Condenser

   The P820 from AKG is a multi-pattern side-address condenser microphone with a tube preamp well suited to record female & male vocals, brass instruments, guitars, and drums, in professional and project-studio settings. With a large 1" gold-sputtered dual-diaphragm capable of handling sound-pressure levels up to 155 dB and ECC83 dual-triode circuitry that adds even-order harmonics to the signal, this microphone delivers the typical warmth and three-dimensional sound tube microphones are famous for.

The P820 connects to its remote control via a dedicated 7-pin XLR audio/control cable. Nine discreet polar patterns can be selected from the control unit. These patterns are virtually frequency-independent so that reflected sound is reproduced accurately and without coloration. Also located on the control unit you will find a switchable low-cut filter at 80 Hz to help reduce rumble & wind noise, and a switchable 20 dB pad for distortion-free recording of loud sound sources when close-miking.

The P820 is built to resist high temperatures and humidity. The all-metal body and sturdy front grille improve rejection of RF interference and protect the microphone from the rigors of studio handling.

Features

• DbxsLr4MV-m3EOA_5T">
• Cardioid, Omnidirectional & Figure-8
• Dual 1-Inch Capsule
• Switchable 20 dB Pad
• Switchable Low-Cut Filter at 80 Hz
• 155 dB Maximum SPL
• Remote-Control Unit
• 9 Selectable Polar Patterns
• Audio/Control 7-Pin XLR Cable
• Spider Shockmount
• Metal Carrying Case

SPECIFICATION



General

Audio Frequency bandwidth : 20 to 20000 Hz

Equivalent Noise Level : 16 dB-A

Sensitivity: 20 mV/Pa

Signal to Noise: 78 dB-A

Preattenuation Pad: -20 dB

Bass Cut Filter: 80 - 12 dB/octave (selectable on remote control unit) Hz

Electrical Impedance: <= 200 Ohms

Recommended Load Impedance >= 1000 Ohms

Audio Output

Type : Balanced XLR

Gender: Male

Contacts : 3-pin

Dimensions / Weight

Length: 212 mm

Diameter: 54 mm

Net Weight: 765 g

Power Supply

Primary Fuse: 125 mA / 250 V slow-blow

Powering: 210-240 VAC or 110-120 VAC (selectable)